Home inspections on new construction

Last updated

How a buyer’s inspection of a new house differs from a certificate of occupancy, a phase visit before drywall, and a state new-home warranty.

Fresh paint does not mean the flashing, the panel, or the soil gas under the slab were checked for you. A city occupancy approval, a builder’s warranty statute, and a private inspection each answer a separate question. Buyers who treat one of them as a substitute for the other two often find out the difference after the walls are closed.

An occupancy certificate is the building official’s document

In California, the 2025 Building Code, Title 24, Part 2, section 111.1, says a building or structure shall not be used or occupied until the building official has issued a certificate of occupancy. The same section says issuance of that certificate shall not be construed as an approval of a violation of the code or of other ordinances of the jurisdiction. Certificates that pretend to authorize a violation are not valid. Section 111.2 says the building official issues the certificate after inspecting and not finding violations of the code or other laws the department enforces. The certificate includes, among other things, a statement that the described portion has been inspected for compliance with the code, the edition of the code under which the permit was issued, and the use and occupancy. Section 111.4 allows the building official to suspend or revoke a certificate issued in error, issued on incorrect information, or issued where the building is later determined to violate the code or another ordinance. (up.codes)

Read that closely. The certificate records the building official’s inspection and the legal permission to occupy. It also says, in the code text, that issuing it is not approval of a violation. It is not a private home inspection commissioned by the buyer, and it is not a promise that every concealed condition was opened up. Other states and cities adopt codes of their own. Confirm the certificate rule with the building department that issued the permit for the house you are buying, rather than assuming California’s section number applies on a different state’s job site.

A buyer’s inspector is not standing in for that official. The Texas Real Estate Commission’s property inspection report says a real estate inspection is not an inspection to verify compliance with any building codes, and that it does not imply insurability or warrantability. That sentence is Texas’s form, not a national building code, but it shows how a regulated inspection report refuses the job people sometimes assign to it. (trec.texas.gov)

What a phase visit can see that a final visit cannot

ASHI describes new-construction and phase inspections as different from an inspection of an existing house because they look at parts that will not be visible later. The association says a pre-drywall visit, or a phased series of visits, can show build quality that a normal home inspection cannot. Phased visits have to follow the builder’s schedule. ASHI says they typically include a foundation inspection and a framing inspection after mechanical, electrical, and plumbing systems are in place, and before insulation, drywall, and wall cladding. It says the final inspection should be finished before closing, with time left for the builder to complete repairs the buyer and builder agree on. ASHI also says that final visit is the same kind of inspection as a standard home inspection. (homeinspector.org)

ASHI publishes a separate auxiliary standard for inspectors who voluntarily use it on residential predrywall inspections, during new construction or during remodeling. Inspections that follow it are done by a construction generalist, not a technical specialist. They do not include or confirm conformity with building codes and other governmental laws, with manufacturer installation instructions, or with construction plans, drawings, and specifications. They do not provide a warranty or guarantee of the property or of the inspected components. The standard says the visit should occur after the foundation, the floor, wall, and roof structure, the plumbing and electrical rough-in, and the windows and exterior doors are installed. The client, not the inspector, schedules the visit with the builder or owner and gets permission to enter. The inspector is not required to inspect or report on components that are not installed, not visually observable, or not readily accessible. The standard applies to one- and two-family dwellings, townhouses, and associated garages and carports. (homeinspector.org)

If your contract limits when a buyer’s inspector may enter the site, that limit is a contract term. Ask your agent or a lawyer how it interacts with the builder’s schedule. This site cannot interpret a purchase agreement.

A statutory warranty is a clock, and only in the states that enact one

Some states impose warranties on new homes by statute. Minnesota is one example, not a national rule. Minnesota Statutes § 327A.02 says that in every sale of a completed dwelling, and in every contract to sell a dwelling to be completed, the vendor warrants to the vendee that:

  • for one year from the warranty date, the dwelling will be free from defects caused by faulty workmanship and defective materials due to noncompliance with building standards;
  • for two years, it will be free from defects caused by faulty installation of plumbing, electrical, heating, and cooling systems due to noncompliance with building standards;
  • for ten years, it will be free from major construction defects due to noncompliance with building standards.

The warranties survive the passing of title. “Dwelling” in that chapter means a new building, not previously occupied, constructed for habitation. It excludes items such as detached garages, driveways, landscaping, and fences. The warranty date is the earlier of the initial vendee’s first occupancy or the date the initial vendee takes legal or equitable title. “Major construction defect” means actual damage to a load-bearing portion, including damage from subsidence, expansion, or lateral soil movement, that affects the load-bearing function and vitally affects, or is imminently likely to vitally affect, residential use. Damage from soil movement caused by flood, earthquake, or other natural disaster is excluded from that definition. (revisor.mn.gov)

The same chapter sets a process, not an automatic repair. The owner must allow the vendor to inspect. That inspection is to be performed within 30 days of the statutory notice. Within 15 days after that inspection, the vendor must provide a written offer to repair that states the scope and the proposed dates. If the vendor fails to inspect or fails to offer or perform agreed repairs, the owner may sue. Other claims have to go through the state’s home-warranty dispute process, or wait 60 days after the written offer, before a district-court case. None of that is a walkthrough you can skip before closing. A warranty claim is a later remedy, on the terms of that state’s statute, for defects tied to building standards. It is not a visual survey of the house on the day you receive the keys. (revisor.mn.gov)

Other states write different warranty rules, and some do not impose this kind of statute at all. Before you rely on a one-year or ten-year period, read the statute or the written warranty for the state where the house is, and talk with a lawyer if a deadline is close.

Radon is not settled by new construction

EPA says any home can have high radon, including new homes and homes without basements. For a new home, EPA says to ask whether radon-resistant construction features were used and whether the home has been tested. It also says every new home should be tested after occupancy, even if those features were built in. If a test is at or above 4.0 picocuries per liter, EPA says to activate a passive system by installing an in-line fan and to call a radon mitigator about that fan. (epa.gov)

EPA’s action-level page adds two numbers that buyers mix up. EPA recommends fixing a home if the radon level is 4 pCi/L or more. Because no safe exposure level is known, EPA also recommends that people consider fixing levels between 2 and 4 pCi/L. The agency estimates the average indoor concentration in U.S. homes at about 1.3 pCi/L, and the average outdoor concentration at about 0.4 pCi/L. A new house is not exempt from the test. EPA and the Surgeon General’s recommendation to test is also printed on HUD’s home-inspection notice. Testing during a purchase has its own cautions about closed-house conditions and device interference. Use EPA’s Home Buyer’s and Seller’s Guide, or a qualified tester, instead of improvising a protocol. (epa.gov)

A sequence that matches the work, not a national calendar

The following order is an illustration of how the documents above fit together. Treat it as a pattern rather than a required schedule; your builder’s contract may set different dates.

  1. When the builder says foundation, structure, and rough-in mechanical, electrical, and plumbing work are in, and before insulation and drywall, ask whether a predrywall visit is allowed. ASHI’s consumer page describes that timing. The auxiliary standard still will not certify the plans or the code.
  2. Before closing, schedule the final inspection early enough to read a written report and to talk with the builder about items you want corrected. The CFPB’s general advice applies here too: schedule soon enough to resolve problems, attend if you can, and hire someone accountable to you rather than someone paid by another party. (consumerfinance.gov)
  3. Ask for the certificate of occupancy, or your jurisdiction’s equivalent, and read what that local document actually certifies. Keep it with the private report. They are not duplicates.
  4. Ask whether radon-resistant features were installed, then test. EPA says to test after you occupy the house even if the features are there.
  5. If your state has a statutory new-home warranty, note the warranty date and the notice steps before a small item becomes a late claim. Minnesota’s clock is one example.

A builder’s punch list from a customer orientation is a third paper, separate from both the city certificate and the private report. Keep all three. If a comment on the private report calls for an engineer, a sewer camera, or another specialist, that request is outside a general visual visit. See home inspector versus specialist inspections before you assume the phase inspector already did that work.

No inspection outcome described here guarantees a defect-free house or a successful warranty claim. If a safety issue is urgent, deal with the immediate hazard and then use the written report, the permit record, and a qualified contractor or design professional to decide what comes next.

Sources

  1. 2025 California Building Code § 111.1, Certificate of occupancy
  2. Home inspection specializations and extra services | ASHI
  3. ASHI auxiliary standard for residential predrywall inspections
  4. Minnesota Statutes § 327A.02, Statutory warranties
  5. Minnesota Statutes § 327A.01, Definitions
  6. How to protect your family from radon when buying a newly built home | US EPA
  7. What is EPA's action level for radon | US EPA
  8. Schedule a home inspection | Consumer Financial Protection Bureau
  9. Property Inspection Report Form (REI 7-6) | TREC